Survey please help Fills shots and refill at pressure.

[Tenderfoot91]

P Rod
Fill 2100
32 shots at just under 12 ftlb.
End at 1500 just flat drops off
Settings from full counter clockwise for both.hammer tention big Allen 5 1/4 clockwise striker smaller Allen 2 1/4 clockwise
Transfer port one size bigger . Extrem speed under 25fps high was about 602 low was 580 something just going from memory but just under 12 ftlb. That is no more than 614 with 14.3 grain pellets and its high was under that it will be my field target pistol.
Take Care,
Don

[Glenn70]

- .25 cal Marauder, owned it about two months
- Around 3,000 psi, I never try to go over recommended max psi.
- usually just two mags (16 shots)
-about 2100 to 2000 psi, I'm sorry I don't pay that much attention to the exact pressure...I just take note of when the shots start to drop from my point of aim.

[Glenn70]

- .25 cal Marauder, owned it about two months
- Around 3,000 psi, I never try to go over recommended max psi.
- usually just two mags (16 shots)
-about 2100 to 2000 psi, I'm sorry I don't pay that much attention to the exact pressure...I just take note of when the shots start to drop from my point of aim.

[Utard]

Has all of this data been compiled and listed somewhere?


Mrod
.177
3000
1900 ? whatever 60 shots takes it to?
60 shots

[N1YDP]

ANYONE TESTED WITH CO2?

[duga]

MRod
.25
fill to 3100 psi on gun but tank says 3200
HDD
20 shots brings it down to 2100
Velocity between 858 and 883fps with Kings
Velocity screw 5 1/2 turns ccw (fyi, .25 needs more to be fully open)
Hammer Spring 5 1/2 turns cw
Striker 1 turn cw

[Curtisair]

Marauder .177
Stock tune
Beeman Kodiak match extra heavy
Start pressure 2950
50 shots
End pressure 2050
876-841 fps

If I start at 2825 and end at 2225 (sweet spot)
I get 30 shots same pellet
876-859 fps

Curtis

[1stmaraudershane]

If you're trying to figure out how many shoots you can get out of your room rifle I noticed on a AOA website they have a calculator fill chart that will tell you anything about Phil pressures and shots with a calculator online they made.

[1stmaraudershane]

I have had allot of time on my hands being disabled and figured out allot on the Benjamin marauder .25 so ill help answer any questions. I figured out it takes about 260 pumps to fill from nothing but after that the easy way to stay filled with a pump i saw was to shoot about 3 clips witch is 24 shoots and maybe more deepening on your settings and then give it 30 pumps and u will stay in that sweet spot of power and accuracy. the only catch is get a hdd debounce device it saves so much air and gives it more power and its hard to explain but for 30 bucks u can make it much easier on your self. I cant even use the pump cause of my disability but i have learned about all i can about it cause i have had it since December 2011 and still cant use it with out a tank but i cant afford that but did a ton of research on that to and found out how bad the cheap sets are but found the company that makes the carbon fiber tanks and the valves and they do layaway too so after all my research all these months i put up the add that air hog is the best i have found and If i can get the word spread they are part of the air gunners acc and trying to get the price down hopefully close to a pump one day so look them up and please pass this on to everyone cause it will help us all if we do.

[titan_wonder]

cal .177

start 3000psi
end 2200psi
tune bstanley 3 oring inside
speed 885-905

sweet spot 40 shoot total 50 shoot

my mrod very accurated , I dont know compare with my hw100 , both super accurated