MarauderAirRifle.com

[rambosky]

Does anyone have medium height rings with a 50mm objective scope lens on their Marauder? I got the package deal from Pyramyd Air with the Leapers UTG high rings and a 4-16x50 Leapers scope. I can't get a good cheek weld on the butt stock. I'm hoping the medium rings will clear the 10 shot clip and the objective end of the scope will clear the barrel shroud.

Thanks.

[Supercharged86]

Hi Rambosky, Welcome to the forum. Are the scope rings that came with your setup model #RGWM-25H4? If so, this ring set has a scope tube height of 18mm. The medium ring set has a height of 14mm and the lows are 10mm. So if you have at least 4mm of clearance on the objective lens and magazine then you should be good. Cheers. Steve

[rambosky]

Thanks for the reply.

I don't know if the rings were the RGPM or the RGWM-25H4. I don't have the packaging any more and I didn't see any part numbers on the rings unless they are underneath and they are already mounted.

But.........if were talking only 4mm's then I feel sure the med rings will work.

Take care,
Rambosky

[Supercharged86]

Rambosky, Well, not exactly. If you have RGWM highs, these are 18mm. If you have RGPM highs these are 21mm. However, both mediums are 14mm, so you'll either have a difference of 4 or 7 mm. Do your rings have a large single bolt to tighten them (these should be the RGWM's) or two smaller allen key bolts (these should be the RGPM's). Steve

[rambosky]

The two smaller hex screws. I still have more than 7mm clearance.

Thanks,
Rambosky