Help support the forum and get %15 Off the Marauder and Accessories direct from Crosman using the coupon code MROD4RUM by CLICKING HERE

[gunlocators]

I just got a 100cu ft scuba rated at 3300psi if the scuba shop will fill to 10% over if my calc are correct thats about 3600psi and 3000-2000 then refill my calc showed about 30 refills. It cost me $200 for the tank brand new

[RayK]

I have one of the 3500 psi steel 120 co ft tanks I used to use for scuba. It works good and I can get fills at dive shop.

Only negative is it is very heavy.

Ray

[joshncarol]

I have one of the 3500 psi steel 120 co ft tanks I used to use for scuba. It works good and I can get fills at dive shop.

Only negative is it is very heavy.

Ray

Ray,

My 95 cu in Benji tank lasted me a very long time on my P-Rod. Very portable too. Save the steel tank for your M--Rod.

[RayK]

I'm getting a pump for my P-rod. It just seem right. Fill is only 2800 and air tube is small.

I'll use tank for my rifles where pumping is just too much work.

I still believe guppy with shoebox is the hot ticket. Is your 90 cu in about same size as guppy?

Ray

[joshncarol]

Is your 90 cu in about same size as guppy?

Ray

Ray,

4.625"x14.625"
4.6 lbs.

I have mine in an old camelback. I can sling it on my back and stays out of the way with M-Rod on a sling.

[Rob@NinjaAir]

If you guys are looking for a smaller 4500psi cylinder like what is used in paintball, we have released a regulated version for $300 retail. They come with either our Ninja logo or the Air Venturi logo, depending on where you purchase. These are a USA machined and assembled products and backed by our full warranty. Just wanted to make sure you guys knew about our option as well.

Here's a link to the Air venturi version so you can check it out. http://www.pyramydair.com/s/a/Air_Ventu ... Cu_In/4708

These can be purchased directly from Masked Marauder on these forums.