Where can I buy a Lother Walther barrel?

[Pulps]

Hi,

I've searched but have been unable to find an actual person or place selling a drop in LW barrel for my Synrod .22. I would like to find one that will bolt right in without any modifications. Any help would be great appreciated!

[RayK]

Two guys I know of who do that type of work are:

Jim Gaska http://www.marmotmilitia.com/
Dan Brown [email protected]

Ray

[DR650]

Two guys I know of who do that type of work are:

Jim Gaska http://www.marmotmilitia.com/
Dan Brown [email protected]

Ray

Jim gave me a run around and another forum member stepped up and helped me out with a blank. I machined the fit myself

[PB_Matrix]

I want a drop in LW or better quality barrel myself......

[pielet97]

Two guys I know of who do that type of work are:

Jim Gaska http://www.marmotmilitia.com/
Dan Brown [email protected]

Ray

Jim gave me a run around and another forum member stepped up and helped me out with a blank. I machined the fit myself

Any guidance for the masses? Part number, level of machining skill or machines required?

thanks

[int3man]

Two guys I know of who do that type of work are:

Jim Gaska http://www.marmotmilitia.com/
Dan Brown [email protected]

Ray

Jim gave me a run around and another forum member stepped up and helped me out with a blank. I machined the fit myself

Any guidance for the masses? Part number, level of machining skill or machines required?

thanks

With a lathe no problem, Turn the O.D. Down from .5 to ~.47 adding room for the Shroud anchor. Grind seats for the barrel anchor screws and the shroud anchor and you are golden! Turn the business end down from, .5 to .47 for the Air Stripper. Install in Rifle go forth and shoot Bulls. Personally I had not touched a lathe in 25 years and 30 minutes later I was shooting.
Michael :- )

[SHOOTINIT]

.630 lother poly...counterbored breech..

[DR650]

I reamed my receiver out to .500 and eventually turned the .630 barrel down to this size to snuggly fit the .500 reciever
The hardest part was cutting the internal O ring. Motorhead has another solution to this but I went the hard way. Reaching inside with an internal O ring tool and using digital readouts cut it blind
I did 5 practice O ring grooves before I knew my blind method was right and did it to my barrel
I had a custom air stripper and it too was .500 so I just turned the end of the barrel down to match
While it is not hard for someone with experience and the equipment it is not for everyone
to work to .001 is easy, I work to .0001
I also have a mill so the flats and drilliing the barrel was easy, including putting in the flat for the O ring

I don't believe anyone having just a lathe can do it.

[DR650]

my stock barrel and receiver beside my new .630 LW barrel and I left it full length

[DR650]

I reamed the reciever to .500 before turning the barrel. It is easier to custom fit the barrel to the receiver then the other way around
If Jim does a barrel for you it is turned to a certain dimension and if your receiver is oversize it is not a great fit This way I could make a snug fit
Reamers also not only come in even sizes like .500 or .501 but they also come in .0001 sizes or eg .5015 You can get another decimal point