replacement hammer spring

3rd Party Stocks, Barrels, Regulators, air tube extensions, etc. and where to find them.

Re: replacement hammer spring

Postby jdills on Tue Jun 08, 2010 5:50 am

thanks,just recieved new springs from msc,going to change out and check the difference
jdills
 
Posts: 3
Joined: Mon Jun 07, 2010 9:13 am

Re: replacement hammer spring

Postby Suburban on Tue Jun 08, 2010 9:49 pm

dogwood wrote:it's actually quite easy, if you have a scope on the gun, take it off. next you'll need to pull the bolt, remove the action from the stock, remove the bolt index screw (or what ever it is called) the big slot screw on the top of the receiver, then remove the hex bolt under that. after that flip the gun over and remove the hex bolt from the rear of the trigger mechanism, be careful as this will allow the rear piece to pop off.

when you remove that the main spring will probably come out with it, if not you should be able to see it and pull it out by hand

hope that helps




Bolt Index Screw is what I have called the Bolt Tension Screw. You don't have to remove it. I think I only backed it out 2 or three turns. There's a ball bearing and spring in there.
Suburban's Domain - My website. Firearm information, product reviews, optics, 2nd Amendment rights articles. Marauder (.177cal) Review Posted. Review Part 2 posted.
Suburban
 
Posts: 9
Joined: Sun May 23, 2010 10:22 am
Location: Delaware County, PA

Re: replacement hammer spring

Postby Walx on Wed Nov 03, 2010 2:25 pm

jdills wrote:thanks,just recieved new springs from msc,going to change out and check the difference


Could you tell a difference with this spring?
Walx
 
Posts: 96
Joined: Sun Sep 19, 2010 1:05 pm
Location: Mississippi

Re: replacement hammer spring

Postby jlands on Wed Nov 17, 2010 9:00 am

has anyone tested new spring yet?

jared

jlands
 
Posts: 68
Joined: Wed Sep 22, 2010 7:39 pm
Location: Baker, La

Re: replacement hammer spring

Postby ssscottg on Wed Nov 17, 2010 1:32 pm

Hi Jared,

I installed the spring and tested it briefly. It was much stronger than the spring in my 22 so it wased a bunch of air and it did not push the pellet much faster. At that time I did not want to introduce another variable into the mix and restart my velocity testing because I was in the middle of barrel testing. However, this winter, I plan to reinstall and dial back my pretenstion or hammer stroke to see if I can get better results with my standard deviation for velocity.

Regards,
Scott
ssscottg
 
Posts: 109
Joined: Thu Feb 11, 2010 10:30 pm
Location: Sacramento CA

Previous

Return to Marauder Aftermarket Parts and Accessories

Who is online

Users browsing this forum: No registered users and 1 guest