Mrod stock screw

This area is dedicated to the .22 caliber Benjamin Marauder by Crosman.

Mrod stock screw

Postby warrior23 on Sun Jan 16, 2011 4:04 pm

The Mrod stock screw on my 22cal was very loose,I tightened it up but Im not sure what the torque settings are does anyone know?Also was think of putting alittle blue loctite on it would that be a problem.
warrior23
 
Posts: 19
Joined: Thu Jan 06, 2011 4:21 pm

Re: Mrod stock screw

Postby Supercharged86 on Wed Jan 19, 2011 7:40 am

Warrior23, Not aware of any torque setting other than just snug enough. I know what your saying though, it seems like if your not careful you'll over tighten it and pull the bushing right through the stock. Just remember, you have a steel bolt going into the aluminum trigger housing, I might be a little reluctant to use the loctite?? Cheers. Steve
Forum Moderator

Mrod .177 with EunJin 16.1's = A bad day!!!
User avatar
Supercharged86
 
Posts: 832
Joined: Sun Nov 01, 2009 7:14 pm
Location: Cranston, Rhode Island


Return to .22 Cal Marauders

Who is online

Users browsing this forum: No registered users and 2 guests