Page 1 of 1

AOA FX LW Barrel to Prod...Help

PostPosted: Thu Mar 12, 2015 1:48 pm
by BillK
I bought a AOA FX 14" LW barrel. I would like to put it on my Prod. The biggest problem in doing so is to have the groove cut inside the barrel for the probe O-ring. Who Does that?

Re: AOA FX LW Barrel to Prod...Help

PostPosted: Fri Mar 13, 2015 10:09 pm
by int3man
BillK wrote:I bought a AOA FX 14" LW barrel. I would like to put it on my Prod. The biggest problem in doing so is to have the groove cut inside the barrel for the probe O-ring. Who Does that?

Reach out to Motorhead on the forum. He has a shop and can help you out.

Re: AOA FX LW Barrel to Prod...Help

PostPosted: Fri Mar 13, 2015 10:39 pm
by Motorhead
Sadly DO NOT have the tooling to cut the o-ring groove in a steel barrel having to do so via the thimble method.

Re: AOA FX LW Barrel to Prod...Help

PostPosted: Sat Mar 14, 2015 1:52 pm
by BillK
Is the "thimble method" something you could do to this barrel? Asking because I don't know what the thimble method is. :oops:

Re: AOA FX LW Barrel to Prod...Help

PostPosted: Sun Mar 15, 2015 7:06 am
by wimpanzee
Jim Gaska might be able to help. I believe he (used to) do LW barrels, and might still do hammer forged barrels on request.

He is at http://marmotmilitia.com/

Travis at wickedairrifles.com might be able to help, as well.

Re: AOA FX LW Barrel to Prod...Help

PostPosted: Sun Mar 15, 2015 12:27 pm
by BillK
Thanks, I will check it out.

Re: AOA FX LW Barrel to Prod...Help

PostPosted: Tue Mar 17, 2015 8:05 pm
by BillK
Emailed Jim G. and he can do the fitting ect. Sending him the barrel tomorrow. My thanks to you all & this site for your help.
Later, Bill :D

Re: AOA FX LW Barrel to Prod...Help

PostPosted: Wed Mar 18, 2015 12:04 pm
by wimpanzee
Good to hear BillK, let us know how it turns out!